Air Brake Nylon Tube Brass Insert

Assembly

• Cut tubing to desired length
• Slide nut and then sleeve on tubing. Threaded end of nut "A" must face toward connector body.
• Insert tubing into the pre-assembled fitting. Be sure tubing is bottomed in connector.
• Tighten nut to required torque as indicated on chart. Another check on proper assembly is dimension 'A' also noted on chart.

Disassembly

• Remove nut and pull tubing out of connector body.
• The Insert will remain in tubing.

Reassembly

• Push tubing and insert into connector body until it bottoms.
• Thread nut onto connector body and torque as in Step 4

Series
WEATHERHEAD -AIR BRAKE BRASS FITTINGS